Safe Use of P.T.O. Shaft
- Use the correct P.T.O. shafts supplied which are
compatible in power capacity, safety devices and
guarding.
- Consult the operator’s handbook for instructions on
correct P.T.O. shaft overlap, (300mm minimum). The
greater the overlap the better.
- Before start up check that the P.T.O. is securely
connected with guards fitted and with anti-rotation
chains in place.
Chains must be fitted so as to allow sufficient
articulation of the PTO shaft in all positions.
- Do not run the machine with a damaged P.T.O. shaft
or one which is not completely protected.
Repair or replace immediately.
Make sure all bystanders are clear of the
P.T.O. shafts before starting up. Only
approach the shafts when the machine is
completely stopped, with the drive
disengaged, tractor engine switched off
and the key removed from the ignition.
- Do not engage the P.T.O. shaft with the tractor engine
switched off.