Setting Up and Adjustment
Cross Conveyor
The cross conveyor can be extended either to the right or the left hand side of the machine to suit whichever working method is to be adopted.
To unfold - Hold joystick (3) to the left to lower the conveyor from the upright transport position into the horizontal position.
Continue to hold the joystick to the left to move the conveyor into the left hand discharge position or right to move to the right hand position.
Further controls adjust the web direction and conveyor speed as described on page 4.1.
Note: The performance of some of the machine services may be affected if the conveyor is run too fast, depending on the oil flow available from the tractor.
It is always advisable to run the conveyor at a speed fast enough to avoid blockages, but slow enough to allow accurate disposal of material into the row bottoms.
When folding the conveyor for transport - the conveyor web direction switches (9) should not be lit.
Using the switch at the rear of the machine, Fig 4.4.1, activate the conveyor whilst at the same time holding down the conveyor grab arm, Fig 4.4.2.
The moving conveyor will engage the grab arm hooks and fold into the upright position.
Turn knob anticlockwise to open valve and increase steering speed, Fig 4.2.1.
Turn knob clockwise to close valve and decrease steering speed.
Level Adjustment
Cross conveyors have a 2 position level adjustment to suit both standard rear lift and extended rear lift configurations.
This adjustment which is made to the machine before leaving the factory ensures that the cross conveyor remains as level as possible during operation.
Further information on cross conveyor level adjustment and settings can be found in Part 6 of the manual.